Technical data

END USER

Ed.06/2011 13

SECTION 2: END USER

In this section you can find all the necessary instructions for a correct operation of the F2

C Series gas fired unit heaters.

The operation of the F2 C Series gas fired unit heaters are governed by a room

thermostat (not supplied but available as accessory) and the remote control provided with

the heater (see Figure 2).

Here below you can find all the necessary instructions for the correct use of the remote

control.

2.1 FUNCTIONS OF THE REMOTE CONTROL KEYS

Figure 2 – Remote control

The remote control keys have the following functions:

- Key (A): SUMMER/WINTER SELECTION.

Allows to select the “Winter” or “Summer” operation.

Winter operating mode status (

) for winter heating.

Summer operating mode status ( ) for summer cooling (the burner is off, ONLY

the fan/s is/are on).

- Key (B): RESET BUTTON.

Allows to resume normal operation of the heater.

Led (C): LOCKOUT/FAULT INDICATOR LIGHT ( ).( ).

Allows to signal the heater lockout condition and identify the fault (cause which

determines the lockout condition).

For reset instructions and anomaly detection refer to 5.4 FAULT LOCATION of page

42.