Technical data

END USER
Ed.06/2011 15
SWITCHING-OFF
To Have: the heater connected to the gas and power supply lines.
10 - To turn off the heater set the room thermostat to the minimum value. The burner will
turn off, while fans will continue to work until the appliance is completely cooled.
!
It is absolutely forbidden to turn off the heater by cutting the power off since this
operation can damage the appliance. If you cut the power to the heater the axial fans
stop working immediately and the limit thermostat is activated. This last shall be
reset manually.
In case of a long period of inactivity, after the above operation and after the axial
fans are turned off, close the main gas cock and cut out the power by means of the
2-pole switch placed on the power supply line.
SUMMER OPERATION (COOLING)
To Have: the heater connected to the gas and power supply lines.
1 - Close the main gas cock and energize the appliance by closing the 2-pole switch (to
be supplied by the electrical installation technician).
2 - Set the winter/summer key (A) of the remote control to the ( ) position (see Figure
2). In this way, with the burner off, ONLY the axial fan continues to work by moving
the ambient air.
SEASON SHUTDOWN
1 - Turn the appliance off (as described in the SWITCHING-OFF Paragraph) and wait
until the axial fans stop.
2 - Close the main gas cock upstream the appliance.
3 - If you do not need to use the SUMMER function, cut the power off to the appliance
by means of the 2-pole switch located on the power supply line.