Quick Guide Owner's manual

ManualsBrandsRobustel ManualsRoutersM1000 MP

Robustel GoRugged M1000 MP Quick Guide

RT_QG_M1000 MP_v.1.0.0 24.01.2014 1 / 5

Robustel GoRugged M1000 MP Quick Guide

Chapter 1. Product Concept

1.1 Overview

1.2 LED Indicator

After inserting the SIM card into the modem and power on, the LED indicator’s status should be as follow when work

normally:

Name

Status

RUN

1.3 PIN assignment for modem’s DB9 female connector

RS232

RS485 (2-wire)

Direction

DCD

Data+ (A)

M1000 MP  Device

RXD

M1000 MP  Device

TXD

Device  M1000 MP

DTR

Device  M1000 MP

GND

DSR

Data- (B)

M1000 MP  Device

RTS

Device  M1000 MP

CTS

M1000 MP  Device

Summary of content (5 pages)

PAGE 1
Robustel GoRugged M1000 MP Quick Guide Robustel GoRugged M1000 MP Quick Guide Chapter 1. Product Concept 1.1 Overview 1.2 LED Indicator After inserting the SIM card into the modem and power on, the LED indicator’s status should be as follow when work normally: Name Status RUN On 1.3 PIN assignment for modem’s DB9 female connector RT_QG_M1000 MP_v.1.0.
PAGE 2
Robustel GoRugged M1000 MP Quick Guide 1.4 USB Interface USB interface can be used for sending/receiving data and power supply. When USB interface of M1000 MP is used for sending/receiving data as well as power supply, current/voltage output of USB interface which connects to M1000 MP’s USB interface shall at least reach to 1A/5V. Note: Normally, current/voltage output of PC’s USB 2.0 interface is only 0.5A/5V.
PAGE 3
Robustel GoRugged M1000 MP Quick Guide  2.2 Connect the External Antenna (SMA Type) Connect this to an external antenna with SMA male connector. Make sure the antenna is for the correct frequency as your mobile operator with impedance of 50ohm, and also connector is secured tightly. 2.3 Connect the Modem to External Device User can use the serial cable to connect the modem’s DB9 female connector to external controller / computer.
PAGE 4
Robustel GoRugged M1000 MP Quick Guide Chapter 3. Operate the Modem We can operate and configure M1000 MP via AT commands through mini USB port or serial port. This chapter will introduce mainly AT commands examples while configuring M1000 MP. 3.1 AT Command Set M1000 MP supports the guidelines known as the “AT Command Set.” AT Command Set is the industry standard line-oriented command language used to communicate with the modem.
PAGE 5
Robustel GoRugged M1000 MP Quick Guide 3. Select Protocol as “Serial”. 4. Select relevant COM port and match the parameters as below, click the “Next” button to finish this session. Note:you need to match the serial parameters as: 115200,8,n,1, and disable “RTS/CTS”. Note: Please refer to Robustel GoRugged M1000 MP User Guide to get more details about M1000’ configuration. RT_QG_M1000 MP_v.1.0.0 24.01.