User Manual

31
Connecting to a PC
6
Connecting the Meter to a PC Using a USB Cable
Follow the steps below to access diabetes management software on a PC. You can use this software to
view stored results, set the meter time and date, and change the target range.
Plug the small end of the
USB cable into the meter.
1
Plug the large end of the USB
cable into a USB port on the PC.
If the meter is o, it turns on.
2
Start the diabetes
management software
and initiate a data
transfer.
3
Chapter 6: Connecting to a PC
The meter transfers the data
to the software.
4
NOTE
The USB cable does not charge the meter’s batteries. Remove the
USB cable after you have finished.
54461_07947836001_07947836001_01_Inside.indb 31 10/7/16 10:50 AM