User Manual
6 7
Set the Upper value and
Lower value for the new time
block. Select Save.
It may be necessary to change
the start times, end times,
and settings of other time
blocks. Select a time block to
edit and continue to Step8. If
you do not need to make any
changes, select Done and the
addition of the time block is
complete.
NOTE
j The End time of a time block is the same as the Start
time of its following time block. Only an End time
can be changed, which changes the Start time of the
following time block.
j To change the Start time of the first time block, the
time blocks must be reset. See the Resetting All
Time Blocks section in this chapter.
j If the End time of a time block is decreased until it is
the same as its Start time, the time block is deleted.
See the Deleting Time Blocks section in this chapter.
8
157
52297_07167776001.indb 157 10/20/14 11:18 AM