User Manual

Meter Maintenance and Troubleshooting
95
10
Meter Maintenance
The meter automatically tests its own systems every time you turn it on and lets you know if something is
wrong. See Error Messages in this chapter.
If you have problems with the meter or think the results are not accurate, perform a control test with an
unexpired test strip and control solution. If the control result is not within the acceptable range, contact the
ACCU‑CHEK Customer Care Service Center at 1‑800‑858‑8072.
Changing the Batteries
Chapter 10: Meter Maintenance and Troubleshooting
Use your thumb to slide the
battery drawer out of the meter.
1
Remove the old batteries and
place the new ones in the
battery drawer with the (+)side
facing down.
2
Slide the battery drawer back
into position until it locks into
place.
3
NOTE
The meter uses two3‑volt lithium batteries, coin cell typeCR2032. This type of battery can be found in
many stores. It is a good idea to have spare batteries available.
Always replace both batteries at the same time and with the same brand.
The logbook data is saved when you replace the batteries.
52195_AvivaConnect_FDA.indb 95 5/1/14 7:23 AM