User Manual
Table Of Contents
- 1 Introduction
- 2 Putting the Meter into Operation
- 3 Meter Setup
- 4 Testing a Blood Sample
- 5 Control and Proficiency Testing
- 6 Review Results (Memory)
- 7 Extended Functionalities
- 8 Maintenance and Care
- 9 Troubleshooting
- 10 General Product Specifications
- 11 Warranty
- A Appendix
- B Appendix
- C Appendix
- Index
120
5.3 Performing a liquid quality control test
1 Place the meter on a level, vibration-free surface or
hold it in your hand so it is roughly horizontal.
2 Power the meter on by pressing .
You can also power on the meter directly by inserting a
test strip or connecting the power adapter.
3 Wait until the Main Menu is displayed, or log on as
described on page 100.
4 Check the battery level.
5 Check that the date and time are correct. Correct
any wrong entries as described in Chapter 3, Meter
Setup/“Setting the date”.
■ If the battery icon turns red (one bar left), there may
not be enough power left for another test.
■ If there are no bars left in the battery icon, you cannot
perform any more tests. Power the meter off by
pressing .
In both cases, restore power by recharging the battery
pack, or using the power adapter.
Main Menu
09:15 am
05/29/2015
Control Test
Review Results
Setup
Patient T
est