User Manual
Table Of Contents
- 1 Introduction
- 2 Putting the Meter into Operation
- 3 Meter Setup
- 4 Testing a Blood Sample
- 5 Control and Proficiency Testing
- 6 Review Results (Memory)
- 7 Extended Functionalities
- 8 Maintenance and Care
- 9 Troubleshooting
- 10 General Product Specifications
- 11 Warranty
- A Appendix
- B Appendix
- C Appendix
- Index
Putting the Meter into Operation • 2
39
5 Place the cover on the battery compartment. Make
sure that
– the plug connector wires do not get pinched
between meter and cover
– the protrusion on the battery compartment cover
fits into the corresponding groove on the battery
compartment rim
6 Tighten all four screws until snug (do not over-
tighten).