User`s guide

ManualsBrandsRoche ManualsBlood Glucose MeterACCU-CHEK Inform II

Page 6 of 7 200.02 Point of Care ACCU-CHEK Inform ll Blood Glucose Monitoring System

D. The use of another person’s ID in the ACCU-CHEK Inform ll meter is considered falsification

of a document and may be subject to disciplinary action.

16. Notes

a. In any situation where a patient has not been registered, the number 0911911 should be

used as the patient identification number. A custom comment should be entered in the

ACCU-Check with the patient’s name at the time of testing. This will allow for charting and

billing when a financial number is assigned in the future.

b. In special situations, an employee may need to have a glucose test done. If this occurs, the

number 0123456 should be used. This will not be documented as a patient test.

c. You may get an error code if:

Strip is under filled “Type bad dose”

Strip defective or previously used, glucose is <10 or end user did not wait for drop

symbol to appear before applying sample to the test strip -“Strip Defect Error”

17. Reporting Results

a. Data is transferred from the meter into Cerner as follows:

i. Wireless Data Transfer: Results will automatically transfer wirelessly into Cerner if a

wireless connection is currently available upon completion of a test. A wireless

connection is activated when the testing operator touches upon completing a

test. An available wireless connection is confirmed by the presence of at the

bottom of the screen. If is not present, a wireless connection is not currently

available. If a wireless connection is not currently available the meter will

automatically send results as soon as a wireless connection is established. The

meter will connect to Cerner every 10 minutes and transfer new data when a wireless

connection is available even if the meter is powered off. This connection gives the

meter the most up to date settings and ADT information when available.

ii. Wired Data Transfer: Results are transferred into Cerner by placing the meter into a

base unit that is connected to the hospital network through an RJ45 connection

connected to the hospital network). When properly docked the meter will

automatically transfer test results. The following series of screen displays will appear

to confirm that data transfer is occurring:

1. “Connecting,” (meter is establishing connection)

2. “Transferring,” (meter is transferring information)

3. “Idle” (meter has finished communications and is ready to use.)

The meter can be removed and used at any time during the transfer of information.

Any information not completed will be transferred the next time the meter is docked.

When properly docked the meter will communicate every 10 minutes even if the

meter is off. This connection gives the meter the most up to date settings and ADT

information when available. This transfer can occur also when a wireless meter is

docked in a connected base unit.

REFERENCES:

ACCU-CHEK INFORM LL Inform II User’s Guide. Retrieved from: www.poc.roche.com and www.accu-

Clinical Laboratory Improvement Act of 1988 (CLIA’88) Standards.

College of American Pathologists (CAP) Point-of-Care testing checklist. (9/25/2012).

McClatchey, Kenneth, ed. (2002) Clinical Laboratory Medicine Second Edition, Philadelphia: Lippincott,

Williams, &

Wilkins

The Diabetes Educator, Vol 31, No. 6, 849-857 (2005)