User manual

When you turn the meter on, it briefly shows all the display’s

letters, numbers, and symbols. Regularly check that all segments

of each letter, number, and symbol appear. Please compare your

meter’s display to the meter display shown here on this page.

You can display all the letters, numbers, and symbols for a longer

time to allow comparison. To do this, you will turn the meter on

and then hold down the ON-OFF button .

The full display should appear as follows:

The Meter’s Display

Setting Advanced Features

You can access these settings by going to Setup mode. To go to

Setup mode, press the SET button . The date format, flashing,

will appear. Once you are in Setup mode, you’ll use these buttons:

• to change a setting

• to accept a setting (and move on to the next setting)

Note: When you go to Setup

mode, the date format, date,

time format, and time settings

appear first. Press the SET button

to move past the date and

time settings to get to the

advanced settings.