Instructions for Use

5. Assemble the main wing as shown in Figure 7. Use four screws to lock the wing as shown in Figure 8.

Install the battery and Radio installation

Gear

1. Apply the hook tape to the cable end of the battery (fig10).

2. Slide the battery into the battery hatch with the power supply cable toward the rear end of the plane and the

hook tape facing the bottom of the battery hatch. Note: You may need to relocate the battery position to

achieve the correct CG for your model.

Attach the aileron servo leads to the previously installed "Y" harness. Elevator servo lead goes to elevator

channel of your receiver. The rudder servo goes to the rudder channel. Attach the ESC connector to the throttle

channel of the receiver.

6.Glue on the Vortex Generator on the wing tip using the applied glue (fig9).

fig9

fig10

fig11

fig7

fig8

HKM 3.0 x 20