User guide

ManualsBrandsRock-Slide Engineering ManualsCarSTEP SLIDER MOTOR REPLACEMENT

Rock Slide Instruction RSEI 122

STEP SLIDER MOTOR REPLACEMENT INSTALLATION

Important

Before installation, make sure control box has a serial number on

the circuit board. Updated control boxes all have serial numbers. In

order to verify, unscrew cover from control box and look for serial

number on the circuit board. New upgraded motors are only

compatible with new control boxes. If your step slider has a control

box without a serial number, it will need to be replaced in order to

work with the new upgraded motor. Replacement updated control

boxes are available for purchase at Rock-Slide Engineering. Call

435-752-4580 for assistance.

Summary of content (4 pages)

PAGE 1
STEP SLIDER MOTOR REPLACEMENT INSTALLATION Important Before installation, make sure control box has a serial number on the circuit board. Updated control boxes all have serial numbers. In order to verify, unscrew cover from control box and look for serial number on the circuit board. New upgraded motors are only compatible with new control boxes. If your step slider has a control box without a serial number, it will need to be replaced in order to work with the new upgraded motor.
PAGE 2
STEP SLIDER MOTOR REPLACEMENT INSTALLATION 1. Remove the Step Slider in order to access the old motor 2. Remove the old motor from the Step Slider a. Take screw out that holds the piston into the piston pocket b. Remove the stainless steel bolts on front of slider c. Bolt towards rear of slider is a dummy, not holding the motor 3. Remove motor with attached rear bracket.
PAGE 3
4. Install new motor NOTE: When installed, the motor portion of the actuator (the shorter round cylinder) should be facing down, towards the vehicle when installed, not up away from vehicle. The actuator may have to be rotated 180 degrees on the back bracket depending on if the motor is installed on the passenger or drivers side.) When new motors are purchased in pairs, one will come set-up for the driver side and one for the passenger side. Make sure you put the correct motor on the correct side. a.
PAGE 4
d. Screw dummy bolt with nut into hole towards front of slider e. Position back bracket over back hole f. Move steps up or down to position back bracket hole directly in line with frame hole g. Screw bolt through slider into back bracket. No nut required, as it is welded onto bracket h. Tighten all bolts 5. Reinstall step slider to vehicle (use step slider installation instructions) Thank you for choosing Rock-Slide Engineering products. We value your business and welcome your feedback/suggestions.