User Manual

11
RF-SBM102
STEP 6 - Install the soundbar mount on your TV
CAUTION: To offset the shift in height of your TV bracket caused by the soundbar bracket (01), you must use the spacers (16) in
the top hole locations and the washers (17) in the bottom hole locations.
1 If your TV has a flat back, place the 16mm spacers (16) over your TV’s top mounting holes and the interface
washers (17) over the bottom mounting holes.
OR
If your TV has an irregular or obstructed back, place your TV mount spacers over your TV’s mounting holes. Then place
the 16 mm spacers (16) over the spacers on the top mounting holes and the interface washers (17) over the spacer on
the bottom mounting holes.
You’ll need
TV with a flat back
TV mount spacers
TV mount spacers
TV with an irregular or obstructed back
Phillips screwdriver
05 M4 × 30 mm
screw (4)
06 M4 × 50 mm
screw (4)
One type of the following screws (4)
07 M6 × 30 mm
screw (4)
08 M6 × 50 mm
screw (4)
09 M8 × 30 mm
screw (4)
10 M8 × 40 mm
screw (4)
11 M8 × 50 mm
screw (4)
12 M8 × 65 mm
screw (4)
One type of the following
washers (4)
13 M4 washer
(4)
14 M8/M6
washer (4)
16 16 mm
spacer (2)
17 Interface
washer (2)