08-1198 RF-AHD25.fm Page 1 Wednesday, April 30, 2008 1:34 PM 2.5" SATA Hard Drive Enclosure Kit Boîtier pour disque dur SATA de 2,5 po (6,35 cm) Caja para disco duro SATA de 2.
08-1198 RF-AHD25.fm Page 2 Wednesday, April 30, 2008 1:34 PM Rocketfish RF-AHD25 2.5" Hard Drive Enclosure Kit Contents Introduction ................................................................. 2 Safety information ..................................................... 3 Features ......................................................................... 3 Using the hard drive enclosure ............................. 6 Troubleshooting .......................................................
08-1198 RF-AHD25.fm Page 3 Wednesday, April 30, 2008 1:34 PM Safety information • Always read these safety instructions and this User Guide carefully. Keep this User Guide for future reference. • Take precautions to avoid static electricity discharge or short circuits when connecting this enclosure to your computer. • Do not use this enclosure close to water, rain, or high humidity. • Do not use or store this enclosure in damp locations.
08-1198 RF-AHD25.fm Page 4 Wednesday, April 30, 2008 1:34 PM Package contents • • • • • • • • • 2.5" SATA hard drive enclosure Five-pin mini USB cable eSATA cable Two Utility CDs User Guide 5 Volt/1 amp AC adapter An extra swappable cover plate Carrying bag Accessories: • Screwdriver • 4 screws System requirements • PC or Macintosh with an available USB 2.0 port or eSATA port • Microsoft Windows 2000, Windows XP, or Windows Vista operating system or Mac OS X version 10.3.x or higher operating system • 2.
08-1198 RF-AHD25.
08-1198 RF-AHD25.fm Page 6 Wednesday, April 30, 2008 1:34 PM Status indicators Operation mode LED Starting mode Active mode Disconnect mode Description Solid The hard drive is turned on. Flashing Data is being transmitted between your computer and the hard drive. Off The hard drive is turned off.
08-1198 RF-AHD25.fm Page 7 Wednesday, April 30, 2008 1:34 PM To install your 2.5" SATA hard drive in the enclosure: 1 Move the switch lock from the locked to the unlocked position, then open the case. 2 Remove the four screws from the printed circuit board and remove the circuit board from the enclosure. 3 Connect the drive to the SATA connector.
08-1198 RF-AHD25.fm Page 8 Wednesday, April 30, 2008 1:34 PM 4 Secure the drive to the printed circuit board with four screws. 5 Return the printed circuit board to the enclosure, then secure it with the four screws you previously removed. 6 Replace the top of the enclosure, then slide the switch lock from the unlocked to the locked position.