Installation Manual

Specifications subject to change without notice

PUNCH P3-DVC 10" 12" 15"

P3D210 / P3D410 P3D212 / P3D412 P3D215 / P3D415

Nominal Impedance (ohms) 2 x 2 / 2 x 4 2 x 2 / 2 x 4 2 x 2 / 2 x 4

Frequency Response (Hz) 29-250 27-250 22-250

Voice Coil Diameter - inch 2.5 (4-Layer) 2.5 (4-Layer) 2.5 (4-Layer)

(cm) (6.35) (6.35) (6.35)

Displacement - cu. ft. 0.074 0.094 0.107

(Liter) (2.10) (2.66) (3.03)

Fs - Free Air Resonance (Hz) 29 27 22

Qts 0.50 / 0.55 0.48 / 0.52 0.58 / 0.61

Vas - cu. ft. 0.87 1.55 4.98

(Liter) (24.5) (43.9) (141.0)

Xmax - inch 0.528 0.528 0.528

(cm) (1.34) (1.34) (1.34)

SPL (dB @ 1w/1m) 83 85 86

Power Handling-Watts (RMS) 400 500 500

(Peak) 800 1000 1000

SPECIFICATIONS

WIRING CONFIGURATIONS

By varying the wiring configuration of your speakers you can create an

impedance load to match your system.Altering the wiring configurations

gives a range of options for impedance loads. Series, Parallel, or

Series-Parallel wiring configurations are different techniques for wiring

speakers that provide different loads. Series configuration is a string

method where speakers are wired end to end. Parallel configuration

uses two or more speakers wired across common terminals.

Series-Parallel configuration combines both techniques. Choose the

wiring diagram that corresponds to the number of woofers and the

impedance of your amplifier.

SUBWOOFER CROSSOVERS

There are two operational types of crossovers, passive and active.

Passive crossovers (coils or inductors) are placed on the speaker

leads between the amplifier and speaker.An active crossover is an

electronic filter that separates the audio signal fed to different

amplifiers. For optimum subwoofer performance, we recommend

using an active 80-100Hz low-pass crossover at 12dB/octave.