Owner's Manual

Input Clip Indicator Setup
Be sure to disconnect all speakers from
the amplifier.
.6CAUTION
Failure to comply may cause damage to
connected components and/or amplifier .
Increase the source unit volume until the
Input Clip Indicator illuminates red.
Note: Input Clip can be viewed remotely
with optional PLC2.
Decrease the source unit volume slightly
until the light turns completely off . This
establishes your maximum source unit
volume for adjusting the Output Clip
Indicator .
Note: Some source units will not clip.
Amplifier Clip Indicator Setup
Insert test tone or music CD to play for setup .
Adjust the Bass & Treble levels on the source
unit to flat.
Be sure to disconnect Punch
Level Control - PLC (if
equipped) from the amplifier.
Note: Use the 40Hz@ OdB tone (Track 5) for
mono amplifier applications or the 1kHz@ OdB
tone (Track 7) for multi-channel amplifier
applications. Be sure your x-over is switched to
the appropriate filter setting.
Output Clip Indicator
Setup
Turn the source unit volume
down .
MUSIC TESTTONE '
BLUE ~ ./
~r===== ==l BLUE/REO ./ ~
~ ......... ;;;;;;;;;;;;;;; ........................... --! RED A ~
~ . 0. . 2.0
PLJNC:::H
/i\ (l)
12 . 0' ·0. 15
INPUTLEVR
v
Adjust the Input Level knob
until the Output Clip Indicator
illuminates to the appropriate
color. Repeat for all channel
levels of input.
Reconnect all speakers and
Punch Level Control - PLC (if
F:::::::::::::::~==l equipped) to the amplifier. Be
sure to maintain proper ~
speaker polarity . V
11111111
--~~~~-------------------------------~