Owner's Manual

.LhCAUTION:
SAFETY
Before
installation,
disconnect
the
battery
negative
(-)terminal
to
prevent damage
to
the
unit, fire
and/or
possible injury.
PRACTICE
SAFE
SOUND™
Continuous exposure
to
sound pressure
levels over
I
OOdB
may
cause permanent hearing loss.
High
powered auto sound systems
may
produce sound pressure
levels well
over
130dB.
Use common
sense and practice safe sound.
CARTON
CONTENTS
(I)
Pc
Punch
Series
Mid
Range Speakers
•
(I)
Pair of grilles/trim rings
• Mounting Hardware
INSTALLATION
CONSIDERATIONS
Before beginning any installation,
follow
these simple rules:
I.
Be
sure
to
carefully
read and understand
the
instructions before attempting
to
install
these speakers.
2.
For safety, disconnect
the
negative
lead
from
the
battery prior
to
beginning the
installation.
3.
For easier assembly, we suggest you run
all
wires prior
to
mounting your speakers
in
place.
4. Use
high
quality connectors for a
reliable
installation and
to
minimize
signal
or
power
loss.
5.
Think
before
you
drill!
Be
careful
not
to
cut
or
drill
into gas tanks,
fuel
lines,
brake
or
hydraulic lines, vacuum
lines
or
electrical wiring when working
on
any
vehicle.
If
installation
in
a boat, take care
not
to
cut
or
drill
through
the
main
hull.
6.
Never run wires underneath the vehicle. Running
the
wires inside
the
vehicle
or
hull
area provides the best protection.
7.
Avoid running wires over
or
through sharp edges. Use rubber
or
plastic
grommets
to
protect
any
wires routed through metal, especially the firewall.
MOUNTING
I . Determine where
the
speakers
will
be mounted. Ensure an area large enough for
the
speaker
to
mount evenly.
Be
sure
that
the
mounting location
is
deep enough
for
the
speaker
to
fit;
if
mounting
in
a door,
operate
all
functions (windows, locks,
etc.) through their entire operating range
to
ensure
there
is
no obstruction.
2. Refer
to
the
specification chart
to
determine
the
proper diameter
hole
to
cut
for your speaker model. Cutting and mounting templates can be found
at
www
.rockfordfosgate.com.
3. Mark
the
locations for
the
mounting screws.
Drill
the
holes with a
I
/8"
bit.
4. Feed
the
speaker wires through the
cutout
and connect
to
the
speaker terminals.
Be
sure
to
observe proper polarity when connecting
the
wires. The speaker's
positive terminal
is
indicated with a
"+".
Sa.
On
models with slotted holes,
fit
the speaker into
the
cutout and
install
the
screws
in
the slots at
the
top
and bo
tto
m.
This
will
allow
you
to
ro
ta
te
the speak-
er
to
match the remaining mounting holes.
When
aligned, tighten
the
screws.
Sb
.
On
models with a trim ring, fit the trim
ring
over
the
speaker and mount into
place using four
(4)
screws.
6. Tighten
the
screws until
the
speaker
is
snug
in
place
to
prevent rattling.
Do
not
over
tighten the screws.
Example
of
standard
door
installation
Example
of
rear
deck
installation
l