Owner's Manual

10
SPECIFICATIONS
MODEL- PRIME R750-1D R1200-1D
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts*
4Ω Load Mono 250 Watts x 1 400 Watts x 1
2Ω Load Mono 500 Watts x 1 800 Watts x 1
1Ω Load Mono 750 Watts x 1 1200 Watts x 1
Dimensions: Height 1.97" (5.00cm) 1.97" (5.00cm)
Width 6.77" (17.20cm) 6.77" (17.20cm)
Length 9.10" (23.10cm) 11.06" (28.10cm)
Battery Fuse Rating (Amp) External (Not Supplied) 60A 100A
“A” Weighted Signal to Noise Ratio (CEA-2006)
Referenced to 1 Watt into 4 ohms ≥75 dB
“A” Weighted Signal to Noise Ratio
Referenced to rated power into 4 ohms ≥100 dB
Crossover Slope 12dB/octave Butterworth
Crossover Frequency Low Pass variable from 50Hz to 250Hz
Frequency Response 20Hz to 250Hz ±1dB
Signal Voltage Adjustment Range Variable from 150mV to 5V (RCA Input)
Protection Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Punch EQ Variable from 0dB to +18dB @ 45Hz
Input Impedance 20K ohms
Operating Voltage 9 to 16 Volts DC
Balanced Inputs No
Damping Factor >200
THD+N (Total Harmonic Distortion + Noise) < 1.0% @ 4 ohm
Specifications subject to change without notice
* These specifications are CEA-2006 Compliant