Amplifier Quick Setup Source Unit Switched 12V to REM (NOT Required if using high level inputs. Refer to manual for more information.) rn-----~ess than 18" INPUT FRONT REAR I I I PWR I I I :____ ::::~=>-t:=< I + NEG I - - POS Battery B+ GD REM Connect to chassis ground of vehicle *Keep grounds as short as possible. For Motorsport and Boat applications, the ground wire should go directly to the negative battery terminal.
Amplifier Clip Indicator Setup Input Clip Indicator Setup Be sure to disconnect all speakers from the amplifier. Insert test tone or music CD to play for setup . .Lt.CAUTION Failure to comply may cause damage to connected components and/or amplifier. Turn on the source unit with volume set to zero. Adjust the Bass & Treble levels on the source unit to flat. Note: Use the 40Hz@ OdB tone (Track 5) for mono amplifier applications or the 1kHz@ OdB tone (Track 7) for multi-channel ampl ifier applications.
Installation assistance available at: - 0: D. :I u w I- IL I[ www.rockfordfosgate.com/rftech i RM18D2 RM110D2 RM110D4 • RM110D4B Printed in China RM112D4 • RM18D4 RM110D2B • • RM112D2 RM112D4B c!~ 1230-59130-02 • • t,:- <( zw wa: _J (~~ w Date of Purchase: Ii ! I > ♦ @ 012115 RM18D2B • Serial Number: R O C K F O R D F O S G AT E .
Introduction Dear Customer, Congratulations on your purchase of the world’s finest brand of car audio products. At Rockford Fosgate we are fanatics about musical reproduction at its best, and we are pleased you chose our product. Through years of engineering expertise, hand craftsmanship and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve.
Enclosures Enclosures Carton Contents • (1) Marine Grade Subwoofer • (1) Socket head driver bit • (1) Grille • Installation and Operation Manual • (8) Socket Head Stainless Screws Recommended Enclosures This manual outlines two specific types of enclosures that provide distinctly different performance. This section is to help you decide which type is best for your application. Sealed Enclosures Sealed enclosures are the simplest to build.
Warranty Rockford Corporation offers a limited warranty on Rockford Fosgate products on the following terms: Length of Warranty POWER Amplifiers – 2 Years BMW® Direct Fit Speakers – 2 Years All other products - 1 Year Any Factory Refurbished Product – 90 days (receipt required) What is Covered This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate Dealers in the United States of America or its possessions.
AMPLIFIERS TM400X2ad • TM400X4ad TM750X1bd • • TM500X1br TM1000X5ad n ELEMENT 4112>READY™ Installation & Operation
Introduction Dear Customer, Congratulations on your purchase of the world’s finest brand of car audio products. At Rockford Fosgate we are fanatics about musical reproduction at its best, and we are pleased you chose our product. Through years of engineering expertise, hand craftsmanship and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve.
Specifications Mode TM400X2ad Rated Power - 200x2 @ 4 ohm Continuous Power 200x2 @ 2 ohm Rating (RMS) Mea- 400x1 @ 4 ohm* sured @ 14.
Design Features Input Clip Indicator The input clip indicator works in conjunction with the audio source volume knob, illuminating red when audio source reaches it’s clipping point. Input Level Knob The input level control is used to match the output of the audio source. Punch EQ A Gyrator based Punch EQ that eliminates frequency shift with boost. This works along with the crossover switch on the amplifier. [ ~ 0 EO 0.
Design Features Output Clip Indicator The output clip indicator works in conjunction with the input level knob, illuminating to appropriate color depending on the audio content used for the setup. Input Switch (2/4 CH, SUB) --= Setting the 2/4 CH switch to the 2CH. position, switches the inputs to a 2-channel mode, allowing connection to only the front inputs with a 4-channel output. (TM400X4ad, 1000X5ad) - If using a dedicated subwoofer input, be sure the SUB switch is in the ON position.
Installation Contents • Power Amplifier • RCA to 4-pin Molex Input Connector(s) • 16 AWG 4-pin Molex Speaker Connector(s) - (TM400X2ad, T4004ad & TM1000X5ad) • 10 AWG Speaker Connector (TM500X1br, TM750X1bd & TM1000X5ad, Sub Only) • Power Connector • Quick Setup Guide • Installation & Operation Manual • Operation CD- (Test Tones & Installation Manual) • Volt/Ohm Meter • Wire strippers • Wire crimpers • Wire cutters • #2 Phillips screwdriver 8. Avoid running wires over or through sharp edges.
Installation Battery and Charging Amplifiers will put an increased load on the vehicle’s battery and charging system. We recommend checking your alternator and battery condition to ensure that the electrical system has enough capacity to handle the increased load of your stereo system. Stock electrical systems which are in good condition should be able to handle the extra load of any Prime Series amplifier without problems, although battery and alternator life can be reduced slightly.
Installation 2-Channel (Stereo) TM400X2ad Source Unit D.• Switched 12V to REM _ Connect to chassis ground of vehicle *Keep grounds as short as possible ** For high level input; cut supplied input harnesses then use the wire harness color codes below. Less than 18" + POS Amplifier NEG Amplifier WIRE HARNESS COLOR CODE LEFT LEFT RIGHT RIGHT (+) WHITE (-) WHITE/BLACK (+) GRAY (-) GRAY/BLACK min. min. .
Installation 2-Channel (Mono) TM400X2ad Source Unit D.• Switched 12V to REM Connect to chassis ground of vehicle *Keep grounds as short as possible ** For high level input; cut supplied input harnesses then use the wire harness color codes below. Less than 18" + POS I Amplifier NEG Amplifier WIRE HARNESS COLOR CODE LEFT LEFT RIGHT RIGHT 40min. (+) WHITE (-) WHITE/BLACK (+) GRAY (-) GRAY/BLACK .
Installation 4-Channel (Stereo) TM400X4ad Source Unit D.• Switched 12V to REM Connect to chassis ground of vehicle _ *Keep grounds as short as possible ** For high level input; cut supplied input harnesses then use the wire harness color codes below. .- -.
Installation 4-Channel (2ch Stereo & 1ch Mono-Bridged) TM400X4ad Source Unit D.• Switched 12V to REM Connect to chassis ground of vehicle _ *Keep grounds as short as possible ** For high level input; cut supplied input harnesses then use the wire harness color codes below. .--.--·- - I I I I I I I I Less than 18" + NEG POS Amplifier Amplifier WIRE HARNESS COLOR CODE ~;=~o FRONT LEFT LEFT RIGHT RIGHT (+)WHITE (-) WHITE/BLACK (+) GRAY (-) GRAY/BLACK VI~ min. min. 40min.
Installation 4-Channel (2ch Mono-Bridged) TM400X4ad Source Unit D.• Switched 12V to REM _ Connect to chassis ground of vehicle *Keep grounds as short as possible ** For high level input; cut supplied input harnesses then use the wire harness color codes below. Amplifier .--.--·- - I I I I I I I I Less than 18" + POS NEG Amplifier WIRE HARNESS COLOR CODE FRONT LEFT LEFT RIGHT RIGHT (+)WHITE (-) WHITE/BLACK (+) GRAY (-) GRAY/BLACK 40 min. 40 min. REAR LEFT LEFT RIGHT RIGHT illus.-2.
Installation Mono Wiring TM500X1br & T7501Xbd Source Unit D.• Switched 12V to REM Connect to chassis ground of vehicle *Keep grounds as short as possible ** For high level input; cut supplied input harnesses then use the wire harness color codes below. Less than 18" + POS Amplifier NEG Amplifier WIRE HARNESS COLOR CODE LEFT LEFT RIGHT RIGHT IOmin. (+)WHITE (-) WHITE/BLACK (+) GRAY (-) GRAY/BLACK it.
Installation 5-Channel (Stereo & 1ch Mono) TM1000X5ad Source Unit D.• Switched 12V to REM _ Connect to chassis ground of vehicle *Keep grounds as short as possible Less than 18" ------------I ** For high level input; cut supplied input harnesses then use the wire harness color codes below. .
Operation Input Clip Indicator Setup Step 1. Be sure to disconnect all speakers from the amplifier. .L:t_CAUTION Step 2. illus.-3.1 Step 6. ® Decrease the source unit volume slightly until the light turns completely off. This establishes your maximum source unit volume for adjusting the Output Clip Indicator. illus.-3.6 Failure to comply may cause damage to connected components and/or amplifier. Turn on the source unit with volume set to zero. Volume INPUT LEVEL illus.-3.
Operation Adjusting Crossover Frequency Do the following individually for each channel. Placing the crossover switch in the HP position sets the amplifier to the High Pass mode, enabling frequencies above the cut-off point to pass, adjustable between 50-250Hz. illus.-4.1 illus.-4.2 a: Hz FREQ Punch EQ This works along with the crossover switch on the amplifier. When set to Low-Pass (LP) operation, this is a variable Bass Boost.
Troubleshooting Troubleshooting NOTE: If you are having problems after installation follow the Troubleshooting procedures below. Check Amplifier for proper connections. Verify that POWER light is on. If POWER light is on skip to Step 3, if not continue. 1. Check in-line fuse on battery positive cable. Replace if necessary. 2. Check fuse(s) on amplifier. Replace if necessary. 3. Verify that Ground connection is connected to clean metal on the vehicle’s chassis. Repair/replace if necessary. 4.
Warranty Rockford Corporation offers a limited warranty on Rockford Fosgate products on the following terms: Length of Warranty POWER Amplifiers – 2 Years BMW® Direct Fit Speakers – 2 Years PUNCH® & PRIME® Amplifiers – 1 Year Speakers, Signal Processors, Accessories and Capacitors – 1 Year All marine, motorcycle, motorsport products - 2 Years Any Factory Refurbished Product – 90 Days (receipt required) What is Covered This warranty applies only to Rockford Fosgate products sold to consumers by authorized
Installation assistance available at: FIFTECH www.rockfordfosgate.com/rftech 080316 1230-61233-01-A English Printed In China 600 South Rockford Drive • Tempe, Arizona 85281 United States Direct: (480) 967-3565 • Toll Free: (800) 669-9899 R O C K F O R D F O S G AT E .
RFRZ14-FSE [ Serial Number: _ _ _ _ __ Date of Purchase: _ _ _ _ _ I Installation & Operation
Introduction Dear Customer, Congratulations on your purchase of the world's finest brand of audio products. At Rockford Fosgate we are fanatics about musical reproduction at its best, and we are pleased you chose our product. Through years of engineering expertise, hand craftsmanship and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve.
Enclosure Assembly ' ' Fig 1 3
Warranty Rockford Corporation offers a limited warranty on Rockford Fosgate products on the following terms: Length of Warranty POWER Amplifiers - 2 Years BMW®Direct Fit Speakers - 2 Years All other products - 1 Year Any Factory Refurbished Product - 90 days (receipt required) What is Covered This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate Dealers in the United States of America or its possessions.
Installation assistance available at: FIFTECH www.rockfordfosgate.com/rftech "' w '? " "' \.n \.n 6 :l,. 600 South Rockford Drive • Tempe, Arizona 85281 United States Direct: (480) 967-3565 • Toll Free: (800) 669-9899 ROCKFORD FOSGATE.
RZR®FRONT SUBWOOFER ENCLOSURE RFRZ14-FWE [ Serial Number: _ _ _ _ __ Date of Purchase: _ _ _ _ _ ] Installation & Operation
Introduction Dear Customer, Congratulations on your purchase of the world's finest brand of audio products. At Rockford Fosgate we are fanatics about musical reproduction at its best, and we are pleased you chose our product. Through years of engineering expertise, hand craftsmanship and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve.
Enclosure Assembly ---- --- ---·,, Included hardware Fig 1 3
Warranty Rockford Corporation offers a limited warranty on Rockford Fosgate products on the following terms: Length of Warranty POWER Amplifiers - 2 Years BMW®Direct Fit Speakers - 2 Years All other products -1 Year Any Factory Refurbished Product- 90 days (receipt required) What is Covered This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate Dealers in the United States of America or its possessions.
Installation assistance available at: RFTECH www.rockfordfosgate.com/rftech 600 South Rockford Drive • Tempe, Arizona 85281 United States Direct: (480) 967-3565 • Toll Free: (800) 669-9899 ROCKFORD FOSGATE.