User's Manual

Remote Engine Starting:

Press and hold the Remote Start Button until the remote control beeps a

time.

1) Parking lights flash twice and the system will chirp 3 times for

audible confirmation. The 2-Way LCD Pager will give voice

confirmation “Engine ON”.

2) After the Ignition and Accessory circuits turn for a few seconds, the

Starter Motor engages.

3) After Engine Starts and Runs, the Parking Lights flash 3 times. The

2-Way LCD Pager will give voice confirmation “Car Started”.

4) Engine will remain running for programmed run time until reset with

Brake pedal. The system will chirp 4 times with Brake Reset. If

needed, the engine can be turned off with remote transmitter.

5) The 2-Way Pager will give voice confirmation “Engine OFF”.

Notes:

• The remote will display an Icon while vehicle is running.

• The system will attempt to Remote Start 4 times.

• The Chirps with Remote Start can be programmed ON or OFF.

• The Door Locks are programmable ON or OFF with Abort Remote

Start.

• If vehicle doesn’t remote start, the system has onboard LED

Diagnostics.

Remote Start Diagnostics:

If the system doesn’t remote start, the Status LED flashes an error code to identify the

problem area.

• SOLID LED = Valet Service Mode. The system is in Valet Mode. To exit Valet Mode,

turn the Ignition on, press and hold Valet Button for about 5 seconds until LED goes

out. Unit is now out of Valet Mode and should perform a remote start.

• 2 LED Flashes = Problem with Hood Switch. Make sure hood is closed.

• 3 LED Flashes = Problem with Brake Switch. There could be a bad brake light.

Many dual filament light bulbs connect the brake and park lights together when bulb

goes bad. Check to make sure all brake lights work properly. If using hand brake, but

sure the hand brake is set.

• 4 LED Flashes = Low Battery Voltage. The Battery voltage is below 11.5 volts.

• 5 LED Flashes = Ignition On before Remote Start.

• 6 LED Flashes = Tach Problem. The Tach source may need to be reprogrammed,

contact your installer.

• 8 LED Flashes = Diesel Wait to Start Time Out (120 seconds).

• 9 LED Flashes = Remote Start Failed 4 Times. Contact your installer to have

system checked out.