User's Manual

6
Prior intrusion Alert:
This system will notify you if the alarm was triggered while you were away. Upon disarming,
there will be four siren chirps instead of the two normal disarm chirps. Check your vehicle
for any signs of a break in or tampering.
The Blue Status LED will flash the trigger zone number as follows:
2 LED Flashes = Sensor # 1
3 LED Flashes = Sensor # 2
4 LED Flashes = Trunk
5 LED Flashes = Door
6 LED Flashes = Hood
7 LED Flashes = Ignition
LCD Remote Paging / Zone Violations:
When the system is triggered, the alarm sends a paging signal to the remote. If you are
within range, you will receive a paging signal that will display of what caused the zone
violation. The 2-Way LCD Pager will also vibrate and give voice confirmation of “Door,
Hood, Trunk, Ignition or Sensor Trigger” to notify you the vehicle has been tampered with.
The LCD remote will keep a detailed record of the trigger zone, time and date (up to 4
trigger violations).
Pre-Warning Shock Protection:
The Pre-Warning (Warn-A-Way) feature will activate when a low-level Light Shock or
vibration is detected by the system’s shock sensor. The alarm will chirp the siren 6 times to
help deter any further tampering with the vehicle. You will receive a paging signal that will
display an Button of a hammer hitting the vehicle. The 2-Way LCD Pager will also vibrate
and give voice confirmation of “Sensor Warning” to notify you the vehicle has been
tampered with.
Passive Arming Mode: (Option # 6-3)
Passive (automatic) Arming occurs 30 seconds after the ignition is turned off and the last
door is closed. Upon closing the last door, the LED will be flashing rapidly to confirm passive
countdown. If a door is reopened within the 30-second period, the LED will turn OFF as
countdown stops and begin flashing again when the door is closed. Passive arming provides
failsafe protection in case you forget to arm the system.
Passive Locking: (Option # 6-2)
The system can be programmed to passively lock the doors when the system passively arms.
The default setting is OFF because passive locking increases the risk of locking the keys in
the vehicle when the system arms/locks passively, without pressing the remote.
Diagnostics will reset when the Ignition is
turned on or when the system is re-armed.