User's Manual

12
WIRING: 18-PIN Connector Cont.
VIOLET: (+) Door Trigger Input – Zone # 5
Same as the GREEN wire below except this wire is used for vehicles that show a positive voltage (+12 volts) when
the door is open and a ground when doors are closed as in many Ford, Lincoln, and Mercury vehicles.
GREEN: (-) Door Trigger Input – Zone # 5
Identify the wire that reads ground when any door is open and 12 volts when all doors are closed. Some vehicles
may have isolated door triggers. In this case you may need to run additional wires from other doors or go directly to
the wire that triggers the vehicle’s interior dome light. Sometimes newer vehicles contain a separate body control
module (BCM) where the door trigger circuit can be located. Most vehicles will NOT require the use of BOTH Green
and Violet door trigger wires.
BLUE: (-) Trunk Trigger Input – Zone # 4
Input trigger for a grounding trunk pin switch. Connect to existing trunk pin switch that read ground when open. If no
existing switches are available, install new pin switch if desired. Note: DO NOT mount new pin switches in water
pathways.
PINK: (+ or -) Diesel Glow Plug
The Diesel Glow Plug Feature is OFF by default and must be programmed before use. Option # 17 controls whether
the unit monitors the vehicle’s (+ or -) glow plug circuit using the Pink input wire or has a fixed 10 second delay.
WHITE/RED: Tachometer Input:
When installing this system in TACH REFERENCE mode, this wire must be connected to a valid source of AC
voltage. This wire allows the unit to sense the engine running. This is the most reliable method for remote starting.
See Tach Reference Section on Page 22 for more information.