User's Manual

14
WIRING: 4-PIN Shock Sensor (22 Gauge wires)
SHOCK SENSOR: There are 2 sensor ports (zone 2 and 3) on the alarm module. The sensor supplied with this
system does not require any additional wiring. Simply mount the sensor in a suitable location. It can be tie wrapped
to a cable harness or mounted to a plastic panel. Plug sensor into Sensor Plug # 1 for zone 2, and adjust the
sensitivity. There are 2 LED’s on the shock sensor to assist you in adjusting sensitivity. The Green LED indicates
the “Warn Away” level and the Red LED indicates a full alarm shock sensor violation.
The adjustment knob next to Red LED is for trigger.
The adjustment knob next to Green LED is for Pre-Warning.
Antenna Plug
Valet Plug
LED Plug
Sensor Plug # 2
Sensor Plug #1
MAIN MODULE
(Zone # 3)
(Zone # 2)
Data Plug
The Sensor Plug #2 is zone 3 for an optional sensor.