User's Manual

Manual Transmission Mode

MANUAL TRANSMISSION INSTALLATION: Requires Tach Wire connected and programmed

After programming Option #26-2 or #26-3 for manual transmission mode, the Door Trigger and Hand Brake wire

must be connected for the manual transmission remote start procedure. A Databus module can also supply the

Door and Hand Brake status signal on most late model vehicles. Please check Databus module features before

connecting door and hand brake wires. A door opening will now cancel a remote start that was previously “set-up”

by the user. The Hand Brake and Door Trigger is a safety feature to cancel a remote start. Note: You can’t use the

interior lights as a door trigger if the interior lights turn on with ignition off.

MANUAL TRANSMISSION EXIT PROCEDURE:

1. Option 26-2: With engine running and vehicle in neutral, set parking brake, then press “Idle Down” Icon or

remote start on transmitter. The remote starter will turn on and take over operation of the vehicle.

2. Option 26-3: With engine running and vehicle in neutral, set parking brake. The remote starter will turn on and

take over operation of the vehicle.

3. Remove key, exit vehicle (remote starter unit must “SEE” door opened, then closed with engine running).

4. Press Lock button within 10 seconds of closing door to arm system with “Idle Down” (engine stays running).

Press Lock a 2

time to cancel “Idle Down” (engine turns off) and set up Manual Transmission Mode.

5. Press Lock button after 10 seconds to Arm system, lock the doors and shut down the engine. From this point, the

system will remote start the engine unless a door is opened or the alarm is triggered (either function will cancel

the remote start sequence).

Note: Turbo Timer in Manual Transmission Mode. After the alarm is armed, the engine will remain running for the

Turbo Time setting.

OPERATION NOTES:

• The 10-second time threshold activates when the door CLOSES.

• Pressing the Lock button before 10 seconds will provide Idle-Down only.

• Pressing the Lock button after 10 seconds will turn off the engine and set the unit up for the remote start feature.

• If the Ignition is turned on, Door is opened or Parking Brake released after performing steps 1-4 above, the unit

will reset.