Instructions

ManualsBrandsROCKLER ManualsdowelROCKLER Heavy-Duty Cross Dowel and Bolt

Review full instructions prior to use for important safety information.

Always check Rockler.com to confirm that you are using the most recent version of instructions for your product.

Heavy-Duty Cross Dowel and Bolt Instructions

Effective August 2022

Summary of content (4 pages)

PAGE 1
Heavy-Duty Cross Dowel and Bolt Instructions Effective August 2022 Review full instructions prior to use for important safety information. Always check Rockler.com to confirm that you are using the most recent version of instructions for your product.
PAGE 2
GENERAL SAFETY WARNINGS This product is designed only for specific applications as defined in the instructions and should not be modified or used for any manner not described in these instructions. Use only recommended accessories. Before using the Heavy-Duty Cross Dowel and Bolt: READ, UNDERSTAND and FOLLOW ALL INSTRUCTIONS AND SAFETY WARNINGS. KEEP THESE INSTRUCTIONS READILY AVAILABLE FOR FUTURE REFERENCE.
PAGE 3
PRODUCT SPECIFIC SAFETY WARNINGS > After installation, periodically check all hardware to make sure it hasn’t come loose during use, and retighten as necessary. Non-permanent blue thread locker also could be used to help prevent loosening. Installation Minimum stock thickness: 11⁄2" Successful installation of this hardware depends on accurate measuring and marking, followed by drilling straight holes that align properly in both workpieces.
PAGE 4
3.5" Top Edges Flush 1.75" 1/4" 1" 0.75" 9/16" diameter bolt hole Stretcher End Fig. 3 3. Switch to the leg to mark the drilling location for the through hole for the bolt. Accuracy is crucial: For the hardware to work, this hole must align exactly with the hole in the end of the stretcher. In our example, the top of the stretcher is flush with the top of the leg, but the outside face of the stretcher is set back 1/4" from the outside face of the leg.