Manual

Specifications
Maximum Input
Input Impedance
Output Impedance
Wah frequency Range
Current Consumption
Power Requirements
+10dBu
1M ohm
1K ohm
400Hz (Heel Down) to 2KHz
(Toe Down) 400Hz
35ma
9VDC <=300ma
* CE Approved *
WAH ON LED - This super bright blue LED will be lit when
the “wah” effect is activated. To activate the wah - see point 2.
The blue LED will not be lit when the wah is bypassed.
9-VOLT BATTERY COMPARTMENT - to access pull on
small tab labeled “OPEN”. Replace with a new 9-Volt battery.
Always remember to unplug your guitar cords from the pedal
to conserve battery life. Some battery drain may take place
when unit is plugged in (even if the unit is bypassed).
14
15