User`s manual

4. Rear Panel

1 BALANCED OUTPUT LEVEL control

This control determines the output level at the XLR BALANCED OUTPUTS. Note that the

balanced outputs pass the same signals as the unbalanced outputs, except that the levels

are independently adjustable.

2 (L) BALANCED OUTPUT connector

This balanced XLR connector provides the left balanced output of the Chameleon for

direct use into a mixing console.

3 (R) BALANCED OUTPUT connector

This balanced XLR connector provides the right balanced output of the Chameleon for

direct use into a mixing console.

4 (L) UNBALANCED OUTPUT jack

This 1/4" unbalanced RTS jack provides the left unbalanced output of the Chameleon for

use with a guitar amplifier or rack system setup.

In addition, this jack also allows for the connection of stereo headphones (600ohms

impedance or greater).

5 (R) UNBALANCED OUTPUT jack

This 1/4" unbalanced RTS jack provides the right unbalanced output of the Chameleon for

use with a guitar amplifier or rack system setup.

6 FOOTSWITCH jack

This 1/4" mono jack allows for the connection of a momentary footswitch to control the

Tapped Delay feature of the Chameleon. The Tapped Delay feature allows the player to

set (or reset) the current delay time by tapping the footswitch. The new delay time will be

based on the length of time between two taps. For more information on this feature, refer

to the "Tap Delay" section .

7 REMOTE jack

This 7-pin DIN connector is provided for the connection of a Rocktron All Access

MIDI

footswitch, which can be configured to act as a dedicated remote footswitch for the

Chameleon. This feature allows the user to access Chameleon functions and parameters

via the remote footswitch.