User`s manual

Using the Chameleon with a Rocktron All Access

in REMOTE mode

A Rocktron All Access MIDI footswitch can act as a dedicated remote control for the Chameleon - allowing direct

access to specific Chameleon features and parameters from the footswitch at any time.

To use an All Access footswitch as a dedicated remote, connect the MIDI OUT of the All Access to the

REMOTE jack of the Chameleon using a 7-pin MIDI cable.

Step 1

Reinitialize the controller assignments as shown earlier in this section under the heading "Restoring the

Chameleon Controller Assignments". This will match up the Chameleon's controller assignments to the

All Access. A code of "244" must be entered to initialize only the controller information.

Turn the FUNCTION SELECT control clockwise to "REMOTE CONTROL".

Turn the PARAMETER SELECT control one step clockwise to display "REMOTE".

Turn the PARAMETER ADJUST control to select "ON".

If the Chameleon titles are to be displayed on the All Access, turn the PARAMETER SELECT control

to "TITLE XFER".

To set up the Chameleon for remote operations do the following:

Step 2

Step 3

Step 4

Step 5

Step 6