User`s manual

Turn the PARAMETER ADJUST control to "ON" to enable title transfers from the Chameleon to the

All Access display.

Step 7

To set up the All Access for remote operation perform these steps from the All Access SETUP program:

(See the All Access user's manual for detailed information on editing the All Access)

When operating in Remote mode with a Chameleon, switches 1-10 act as normal preset switches, while switches 11-15 each

perform a special function.

Switch 11 switches in or out the first effect of the current configuration (not including HUSH). This

can be either chorus, flange, tremolo, pitch shift, wah or phase shift.

Switch 12 switches in or out the delay effect.

Switch 13 switches in or out the reverb effect.

Switch 14 can be pressed and held to mute the output of the Chameleon for as long as the switch is

held down. This is especially useful when switching guitars during a live set.

Switch 15 provides instant access to the Tap Delay feature of the Chameleon. Switch 15 can be

used instead of connecting a momentary footswitch to the FOOTSWITCH jack on the rear of the

Chameleon. For more information on the Tap Delay Feature, see Tap Delay in this section.

Set the Operating Mode to "REMOTE".

Set the Bank Size to "10".

Reinitialize only the controller information for the instant access switches and pedals using a code of

"231".

If the preset titles from the Chameleon are to be displayed on the All Access automatically, set the

Remote Title Number to match the Unit ID Number parameter on the Chameleon.

Step 11

Step 9

Step 10

Step 8