Instruction Manual

PITCH SHIFT

Pitch Shifting is used to change the pitch of the input signal to produce one to four harmony notes based on a single

input signal. The

Hush; Pitch Shift; Delay

configuration offers 4 harmony voices while the

Hush; Pitch Shift; Delay; Reverb

configuration offers 2. Each harmony voice may be of any fixed interval - from to one octave above the input signal to two

octaves below—and is selected in 20 cent increments. Increments of one cent (1/100th of a semitone) are also available for

fine adjustment via the Fine parameter.

PITCH SHIFT PARAMETERS

Pitch The

Pitch

parameter determines the harmony note the Intellifex Online will

produce based on the input note. An interval is the distance in semitones

between the pitches of two musical tones (i.e. the distance from an A note

to a C note is considered a minor third interval, this equals 3 half-steps or

300 cents). The Pitch parameter is adjustable in 20 cent increments and

any interval may be selected from one octave above to two octaves below

the input signal. This parameter is adjustable from -2400 cents to +1200

cents—where -2400 is 2 octaves below the input signal, 0 is unison and

+1200 is one octave above the input signal. Each 100 cents (or 5 - 20 cent

steps) above or below 0 represents the amount of half-steps (or semitones)

the harmony note will be above or below the input signal.

Fine The

Fine

parameter allows for fine adjustment of pitch change in 1 cent

steps (or 1/100th of a semitone) for finer adjustment of the harmony note.

Level The

Level

parameter determines the volume of each voice relative to the

other voices of the effect. (This is not the same as the Pitch Shift Level

parameter found in the Mixer Function parameter list.)

Pan This parameter allows you to pan the shifted note to the left or right channel

of the Intellifex Online. It is adjustable from 0 to 100, where 0 is full left, 100

is full right and 50 is center.

Delay This parameter allows for the shifted signal to be delayed up to 418mS

following the input signal. It is adjustable from 0 to 418mS in 2mS incre-

ments.