Owner manual

Controls and Function Descriptions - Cont.

INPUT Jack - using a standard guitar cable - plug your guitar

into this jack.

9-VOLT ADAPTER INPUT - This receptacle requires a 9V

DC adapter (not included) with a 2.1mm coax plug to provide

power to the unit. Please consider using the Rocktron DC

OnTap adapter (sold separately) available from your Rocktron

dealer.

Note: If an adapter other than the Rocktron DC OnTap adapter is used, it needs to be a 9V

DC ltered audio grade type with a current rating of 100ma or greater . The plug is a 2.1mm

Coax jack (Tip is Negative and Sleeve is Positive). Please follow all instructions that appear

on the bottom of the Mike Orlando Signature Wah.

OUTPUT Jack - using a standard guitar cable, plug this out-

put into the next effect in your effect chain or directly into the

input of your guitar amplier.

WAH ON LED - The red LED will be lit when the “wah” effect

is activated. To activate the wah - see point 2. The red LED

will not be lit when the wah is bypassed.

PEDAL ROCKER TENSION ADJUSTMENT - This screw will

allow you to adjust the “action” of the pedal to suit your taste

with the included allen wrench. If you would like a tighter or

heavier movement of the pedal using an allen wrench turn the

screw clockwise. This will increase the torque and tension on

the rocker pedal. If you would like a smoother or softer pedal

movement turn the allen screw counter-clockwise. This will

loosen the tension on the pedal pivot point.