Owner manual

Specications
Maximum Input
Input Impedance
Output Impedance
Wah frequency Range
Current Consumption
Power Requirements
+10dBu
1M ohm
1K ohm
400Hz (Heel Down) to 2KHz (Toe
Down)
20ma or greater
9VDC >=100ma
Place the Mike Orlando Signature Wah (as with all Wah Wah ped-
als) at the beginning of your signal chain. Although, you may place
your wah at any place in your signal chain, it usually sounds best at
the beginning - directly from your guitar (or bass).
Hints and Tips
9-VOLT BATTERY COMPARTMENT - to access pull on
small tab labeled “OPEN”. Replace with a new 9-Volt battery.
Always remember to unplug your guitar cords from the pedal
to conserve battery life. Some battery drain may take place
when unit is plugged in (even if the unit is bypassed).
10
Controls and Function Descriptions - Cont.