Instruction Manual

65
Using the MultiValve with a Rocktron All Access

in REMOTE mode
A Rocktron All Access
™
MIDI footswitch can be configured as a dedicated remote control for the MultiValve—
allowing direct access to specific MultiValve features and parameters from the footswitch at any time.
To use an All Access footswitch as a dedicated remote, connect the MIDI OUT of the All
Access to the REMOTE jack of the MultiValve using a 7-pin MIDI cable, as shown below.
Step 1
Step 2
Reinitialize the controller assignments as shown on page 62 under the heading "Restoring the
MultiValve Controller Assignments". This will match up the MultiValve's controller assign-
ments to the All Access. A code of "243" must be entered to initialize
only the controller
information.
ALL RESTORE 243
To set up the MultiValve for remote operation, do the following:
Operating the MultiValve