Manual
Table Of Contents
- 1. Introduction
- 2. Front Panel
- 3. Rear Panel
- 4. Connections
- 5. Operation
- A. Selecting a preset
- B. Creating a new preset
- C. Storing a modified preset to a different preset location
- D. To copy a preset to a new location
- E. Setting the HUSH® Threshold
- F. Selecting a Power-up preset
- G. Using the Piranha with a Rocktron All Access’ in REMOTE mode
- 6. Special Functions
- A. Factory Reinitialization
- B. MIDI Preset Dump
- C. MIDI Preset Load
- D. Continuous Controller Mode
- SPECIFICATIONS
16
B. MIDI Preset Dump
The Piranha presets can be dumped to a sequencer via system exclusive messages.
Connect a standard MIDI cable from the MIDI OUT of the transmitting Piranha
to the MIDI IN on the receiving sequencer.
Note: Do not allow connection from the MIDI OUT of the receiving sequencer back to
the MIDI IN of the transmitting Piranha.
Make sure the "SYSX RECORD" function is enabled on the sequencer, and start
the sequencer recording.
While holding the HUSH button in, press the CLEAN button to initiate the data
dump to the sequencer.