Reaction Flanger Instruction Manual
Compliance Your Reaction Flanger™ pedal has been tested and complies with the following Standards and Directives as set forth by the European Union: Council Directive(s): Compatibility 89/336/EEC Standard(s): EN55013, EN50082-1 Electromagnetic This means that this product has been designed to meet stringent guidelines on how much RF energy it can emit, and that it should be immune from other sources of interference when properly used.
Precautions Refer all service to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply or plug is damaged, liquid has been spilled or objects have fallen into the apparatus or if the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped. DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. QUALIFIED PERSONNEL SHOULD SERVICE THIS EQUIPMENT ONLY.
Introduction Thank you for purchasing the Rocktron Reaction Flanger. This is classic Flanger pedal design with a vintage voicing that is controllable and adjustable. The LEVEL control allows you to dial in just the right mix of Flange to your signal. The Depth control gives you control over the intensity of the flange. The Rate knob controls the speed of the flange. And, the F.Back control varies the regeneration of the modulated output.
Descriptions
Descriptions continued......... 1 LEVEL Control - This control determines the overall output of the Flange effect. 2 DEPTH Control - This control adjusts thethe intensity of the flange. 3 9VDC Input - This input jack provides 9VDC power to the pedal from the Rocktron DC OnTap 9V power supply (sold separately). 4 RATE Control - This controls the speed of the flange. 5 F.
Descriptions continued......... 6 ON/OFF Leds - These LEDs shows if the pedal is on or off. When the LEDs are lit the pedal is on. When the LEDs are not lit the pedal is off. 7 BATTERY COMPARTMENT and COVER - The 9V battery can be found in this compartment. 8 INPUT Jack - Using a standard 1/4” guitar cable, plug your guitar into this jack. 9 THUMB SCREWS for Battery Compartment. Unscrew these thumb screws to access the battery compartment. 10 FOOTSWITCH - Use this switch to turn on or off the pedal.
Typical Connection
Specifications Maximum Input Maximum Output Input Impedance Output Impedance Current Consumption +8dBu +6dBu 1MΩ 1kΩ 20mA Power Requirements 9V Alkaline Battery or Rocktron DC OnTap Universal Power Supply (sold separately). Negative Tip. Dimensions Weight 125mm x 78mm 61mm 5” x 3.25” x 2.5” 0.7kg 1.
How to change the battery: To change the battery, remove the thumb screws on the top of the pedal and remove the battery compartment cover. Remove the old battery and replace it with a new 9V Alkaline battery. Replace battery in the same area as the old battery was located. Place the battery compartment cover on the pedal and re-insert the thumb screws. Save yourself tons of money in batteries by using the Rocktron DC OnTap Universal Power Supply to power this pedal (sold separately).
Rocktron - A Division of GHS Corporation 2813 Wilber Ave Battle Creek MI 49037 USA www.rocktron.com info@rocktron.com tel: 1-269-968-3351 rev. 12-10-11 2011.
