Digital Modeling Preamp MANUAL o o o o o o 16 Amplifier Emulations Direct Recording Capabilities 128 User Programable Presets Available HUSH Noise Reduction Rocktron's Hallmark Effects Reverb, Delay, HUSH, & one additional effect available at all times! Suggested Footcontroller(s) - Rocktron MIDI Mate, Rocktron MIDI I.T. or Rocktron All Access.
Your Rocktron RepliTone MP preamp has been tested and complies with the following Standards and Directives as set forth by the European Union: Standard(s): IEC60065 Professional Audio/Video or Similar Equipment, EN55013:1997, EN61000-3-2 (1995) EN61000-3-3(1995), EN55020:1995, CSA E65-94 This means that this product has been designed to meet stringent guidelines on how much RF energy it can emit, and that it should be immune from other sources of interference when properly used.
rr Contents 1. Introduction to the RepliTone MP.................................... 4 2. RepliTone MP Quick Start ................................................ 5 3. RepliTone Models ............................................................... 5 4. Precautions .......................................................................... 6 5. RepliTone Emulations ........................................................ 7 6. Front Panel ......................................................................
1. Introduction to the RepliTone MP The Rocktron RepliTone MP is a 24-bit DSP professional guitar preamp & direct recording device containing 16 different amp emulation models and 128 user programmable presets (15 user presets on the front panel with a total of 128 presets available via a Rocktron MIDI footcontroller). The RepliTone MP also offers effect algorithms and superb sound quality.
2. RepliTone MP Quick Start Turn the MASTER VOLUME control all the way down on the RepliTone MP and Power Amp. Using high quality 1/4" guitar cables (standard guitar cables are OK) connection the RepliTone MP to Power amp as such: -RepliTone MP Left Pre-amp "OUT" to - "IN" on the Power Amp -RepliTone MP Right Pre-amp "OUT" to - "IN" on the Power Amp" Plug the supplied power adapter into the AC INPUT socket on the rear panel, and plug the other end into an AC wall socket.
4. Precautions NOTE: IT IS VERY IMPORTANT THAT YOU READ THIS SECTION TO PROVIDE YEARS OF TROUBLE FREE USE. THIS UNIT REQUIRES CAREFUL HANDLING. • All warnings on this equipment and in the operating instructions should be adhered to and all operating instructions should be followed. • Do not use this equipment near water. Care should be taken so that objects do not fall and liquids are not spilled into the unit through any openings.
5. RepliTone MP Emulations Note: Fender, Marshall, Vox, Boogie and other amplifier model designations are all trademarks of their respective owners and are not associated or affiliated with Rocktron. The names are used solely to describe the amplifier tones produced using the RepliTone's emulating software.
6. Front Panel 1 8 2 3 4 5 9 6 7 8 10 11 12 13 14 15 16 1 POWER switch On/Off switch - Note: when powering up your rack be sure to turn all preamps and effects on first before you turn on your power amp. When powering down your rack set up always turn the power amp off first. 2 INPUT jack This ¼" jack accepts the output from the guitar. 3 MASTER VOLUME Controls overall output level of the amp and also headphone volume. 4 PRESET switch Selects one of 16 channels, as desired.
12 DELAY LEVEL control Adjusts the overall level of the delayed signal at the output relative to the direct signal and other effect signals. (Delay is always available.) 13 DELAY TIME button and LED Adjusts the current delay time. To set the delay time, tap the button twice at the interval desired (up to one second). The LED flashes to indicate the set time. For the longest delay time tap button only once.
7. Rear Panel 1 2 3 4 5 6 1 PRE-AMP OUT (To Power Amp) Jacks for connection to a power amp (we suggest the Rocktron Velocity 100 power amp - 2x50 watts - stereo). These are stereo output jacks that should be connected to a power amp input. 2 MIDI THRU/OUT This standard 5-pin DIN connector can be connected to the MIDI IN jack of another device via a standard MIDI cable. There are limitations to the number of devices that can be chained (or series connected) in this fashion.
Please note, however, that this phantom power feature may not work with other MIDI controllers. The Rocktron MIDI Controllers run on 9V AC current - others may not. Therefore, please be sure you are fully aware of the functions and operation of other MIDI controllers before using a 7-Pin DIN cable.
8. MIDI Implementation There are 128 user programmable presets. The first 15 are accessible from the front panel PRESET knob and correspond to MIDI program change numbers 1 to 15. ("Manual" is not a MIDI accessible preset.) The remaining 113 user presets are accessible only via MIDI program changes (program numbers 16 to 128) through a footcontroller. The MIDI IN jack is a 7-pin DIN for phantom powering MIDI controllers, however, 5-pin DIN cables can be used and are most common.
8. MIDI Implementation continued... Dump Functions To dump all presets: place the PRESET switch in the MANUAL position with the unit OFF. Press and hold the DELAY TIME (DUMP) button while turning on the power switch. The STORE (EXECUTE), DELAY TIME (DUMP) LED and the RATE (RESTORE) LED's will start flashing. Release the DELAY TIME (DUMP) button. To dump all the presets, press the STORE (EXECUTE) button. The LED's will flash to indicate success.
Continuous Controller Assignments - Version 1.00 The Controller Assignments for some of the RepliTone MP's parameters such as volume, delay, reverb and effects can be adjusted for "real-time" control by continuous controller assignments or midi and/or expresssion pedal.
9. PC Interface - Download Presets Edit presets with your computer, save, store or share presets with other users. The Replitone MP's pc interface allows you total flexibility with your new product. If you are like most players - sometimes you play electric heavy rock - sometimes the classics - sometimes weddings...the list goes on an on. Within a very short time you can set up all of your gigs and put the presets in the order you use them for each gig using the PC interface.
10. Effects There are some great sounding, Rocktron Intellifex quality effects in the RepliTone MP. To pick the effect you want to hear, turn the EFFECT knob. You can control the character of the effect by tapping the RATE button and turning the EFFECT ADJUST knob. 16 Chorus Depth & Chorus Level Chorus simulates the sound of several guitars playing at once, making the overall sound "fatter".
Effects, continued... HUSH Wah Delay Regen & Delay Pan Phaser Tremolo 1 & 2 HUSH is Rocktron's patented single-ended noise reduction system. The HUSH system contained in the RepliTone MP is a fully digital implementation achieved through Digital Signal Processing (DSP). The HUSH circuit is located after the A/D converter in the signal chain to reduce any noise generated from the guitar and the A/D converter. This insures a quiet input signal to the preamp section.
Effects, continued... Reverb The Reverb function is always available independent of the setting of the EFFECT SELECT knob. It simulates the natural acoustics of playing in a large hall or auditorium. This is also known as "ambience". Reverb is useful for creating a "surf guitar" sound or for adding sustain to clean guitars. Just a touch of reverb will embellish your sound without being discernable as an effect.
11.
Connections, continued.....
Connections, continued.....
Connecting the RepliTone MP to a PA System or Multi-track recording device. The RepliTone MP sounds AWESOME when plugged straight into a PA system. Doing this can eliminate the need to carry your amplifier to the gig. Rocktron's built in speaker simiulation is world class and sounds so good - you might just sell your amp. In this set up you do not need a power amp - just the PA's power.
13. Specifications Input Impedance 470k Maximum Input Level 0dBu Input Jack Output Impedance Maximum Output Level Output Jacks MIDI In 1/4" Mono <150 Ohms +7dBu 1/4 Left and Right 7-pin Din - Pins 6&7 Carry Phantom Power to run Rocktron MIDI Mate and MIDI I.T. Footcontrollers. MIDI Thru/Out Power Requirements Effects Loop Dimensions 5-pin Din 9VAC / 3.4A 1/4" stereo jack (TRS) for send and return. Tip is left channel. Ring is right channel.
Check out some of our other products: Rack Gear: Gainiac (preamp w/12ax7 tube) Chameleon 2000 (preamp w/multi-effects) Voodu Valve (preamp w/12ax7 tube and multi-effects) Prophesy (our top of the line preamp with multi-effects) Intellifex On Line (Multi-effects processor) HUSH Super C (guitar noise silencing system) Vendetta VP4 Preamp (All Tube 4-Channel Guitar preamp - 2 Rack Space) Stomp Boxes: Rampage Distortion, Tsunami Chorus, Austin Gold Overdrive, Vertigo Vibe Rotating Vibe Pedal, HUSH The
Rocktron -A Division of GHS Corporation 2813 Wilber Avenue Battle Creek MI 49015 USA Rocktron Phone: 1-(616)-968-3351 Email: info@rocktron.com Check us out on the web at: www.rocktron.com 2002-0001 Rev.
