Owner's Manual
Wiring Diagram
The CB5 speakers all come equipped with high voltage (70V) transformers and may also be run in an 8 ohm direct mode.
The speaker comes with hard wire leads for the two options. See the gures below for typical 70 Volt and 8 Ohm wiring
congurations.
Speaker Installation
Rockustics recommends using either 14 gauge or 16 gauge direct-burial wire. It is best to lay out the wire to each of the
intended speaker locations before installing the speakers.
Expandable
70V Wiring Diagram
SoundTube MA3501t
8 Ohm Wiring Diagram
(Speakers Wired in Parallel)
Audio
Source
Amplier must be able to handle an 8 Ohm load for this
conguration
White wire