Owner's Manual

'
INSTALL INSTRUCTIONS
Rock Series I
PunkRock™, Rocky Ill, Econorock rM, Rocquette™, Pavarocci™, SoundStone, TuneStonen ", Rocky Tao,
. "· .t .. ',
OctoRock™, Ro , Rockolyth
1
M
Speaker Wiring: All Rock Series (exceptions see below)
1. Unpack speaker from the box.
Warning: Rock speakers may be
heavy, please use caution when
lifting or handling.
Notice: packing peanuts are
bio-degradeable and can be used
in compost.
2. Locate speaker wire on the
underside of the speaker. Strip
wire ends if neccessary.
Speaker Wiring: Terminal Cup (Rockolyth)
1. Unpack speaker from the box.
Warning: Rock speakers may be
heavy, please use caution when
lifting or handling.
2. Locate termincal cup on the
underside of the speaker.
2.
3. Connect the speaker wire to
the input signal wire. Red is
positive, black is negative.
Use included wire nuts to secure
the connection. Step 2 is required
to secure the negative
connection, and then the positive
connection.
For transformer wiring, see chart
below.
3. Connect the speaker wire to
the terminal cup. Red is positive,
black is negative.
Optional Transformer Wiring
64W 120W
0
Black- GND
GND
Red- 64W
120W
Blue- 32W
60W
Yellow- 16W 30W
Orange-
8W 15W
Brown-
4W 7.SW
4. Done.
For information on speaker
placement, refer to section ti tled
"Optimizing Speaker Placement
for Best Sound;' located on page
one.
•
4. To seal the terminal cup for
weatherproofing purposes, use a
silicone gel and caulking gun. Be
sure that wires are connected and
speaker is functioning before
sealing.
15W
Black- GND
Red- SW
Blue- l0W
Brown-15 W
5. Done.
64W, 120W: 6 wire input
1 SW: 4 wire input
Once the proper wires are selected for the desired tap setting, clip or trim unused wires.
Res1dent1al Contact: MSE Audio, 866.663.9770 / 913.663.9770 / salesI(!)mseaud10.com
Commercial Contact: SoundTube Entertainment. 800.647.TUBE / 435.647.9555 / [e-mail] Ultra-Fidelity Outdoor Speakers