ROCKVILLE ASM5 ACTIVE SERIES NEAR FIELD STUDIO MONITORS USER GUIDE
IMPORTANT SAFETY INSTRUCTIONS CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK.) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Do not place this unit on an unstable cart, stand or tripod, bracket or table. The unit may fall, causing serious injury to a child or adult and serious damage to the unit. Use only with a cart, stand, tripod,bracket or table recommended by the manufacturer or sold with the unit.
CONTENTS ASM5 Introduction 4 ASM5 Features/System Controls 5 ASM5 Volume Control/Input Selector 6 Installing and Positioning 7-8 Specifications 9 Troubleshooting 10 3
INTRODUCTION The Rockville ASM5 Active Studio Monitor creates a new performance level in affordable studio monitors. Designed and engineered for refined vocal reproduction, our unique design eliminates high frequency diffraction while providing full range monitoring accuracy and enhanced bass response.
FEATURES/SYSTEM CONTROLS • Ferro Fluid Enhanced 1" Neodymium Soft Dome Tweeter • Talc Filled, Injection Molded Graphite Composite Cone Woofer • Curved front bezel design eliminates standing wave distortion • Waveguide design provides amazing detail and imaging • Computer optimized rear-firing port provides low bass extension loading • Specially wound voice coils produce accurate response along entire frequency spectrum • One Complete Pair with Master / Slave Output Connection with included noise rejection
VOLUME CONTROL/INPUT SELECTOR Turn on main power switch on rear of unit. Speaker will be in STANDBY mode (LED indicator ring will glow red). Push once to exit STANDBY mode. Turn volume control knob left or right to decrease/increase volume. Push again for INPUT mode. Continue to push to cycle through INPUT modes. LED indicator ring will change colors to indicate input source. Push and hold knob for 2 seconds to return to STANDBY mode.
INSTALLING AND POSITIONING The close-field monitor, by definition, reduces room interaction. This can be compared to the conventional stereo configuration or the large monitor arrangement in a recording studio where sounds emanating from the monitor or reflecting off ceilings, walls, and floors, all greatly affect the sound quality.
INSTALLING AND POSITIONING SUBWOOFER PLACEMENT(optional) Ensure the proper phase settings(0 or 180) on subwoofer. Then further adjust the sub’s low pass filter, so that it blends seemly with your ASM5 monitors. When you have finished adjusting the phase and cross-over settings, re-adjust the level of the sub to your personal preference.
SPECIFICATIONS MODEL ASM5 STUDIO MONITORS SPEAKER TYPE 2-WAY POWERED SYSTEM TYPE NEAR-FIELD ACTIVE STUDIO MONITORS LOW-FREQUENCY DRIVER Talc Filled, Injection Molded Graphite Composite HIGH-FREQUENCY DRIVER Ferro Fluid Enhanced 1" Neodymium Soft Dome LOW-FREQUENCY POWER 35WRMS / 70W MAX HIGH-FREQUENCY POWER 15WRMS / 30W MAX FREQUENCY RESPONSE 49HZ - 21,000 HZ SPL 107DB @ 1W/1M AMPLIFIER CLASS EFFICIENT CLASS D CIRCUITRY POWER OUTPUT 50W RMS / 100W MAX INPUT IMPEDANCE 10K OHMS BALANCE
TROUBLESHOOTING Experiencing technical difficulties? Try the following diagnostic tips... NO POWER •Ensure power cord is securely connected to its proper port •AC voltage matches to that of the operating voltage requirements. •The Rockville logo is illuminated on the front panel of the ASM5. If not, turn the power switch off and check the fuse(s).
VISIT US AT: RockvillePro.