User Manual

ATTENTION: To prevent electrical shock, disconnect from power source before installing or servicing. Install
in suitable enclosure. Keep free from contaminants.
ACHTUNG: Vor Installations- oder Servicearbeiten Stromversorgung zur Vermeidung von elektrischen Unfällen
trennen. Die Geräte müssen in einem passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden.
ATTENTION: Avant le montage et la mise en service, couper l'alimentation secteur pour éviter toute décharge.
Prévoir une mise en coffret ou armoire appropriée. Protéger le produit contre les environnements agressifs.
ATTENZIONE: Per prevenire infortuni, togliere tensione prima dell'installazione o manutenzione. Installare in
custodia idonea. Tenere lontano da contaminanti.
ATENCION: Desconéctese de la corriente eléctrica, antes de la instalación o del servicio, a fin de impedir
sacudidas eléctricas. Instálelo en una caja apropiada. Manténgalo libre de contaminantes.
Installation
Montage
Installazione
Instalación
(Cat 100-DMD00, -DMD02 )
Mechanical Interlock Kit
Mechanische Verriegelungs
Kit Entrebarre Mécanique
Kit per Interblocco Meccanico
Kit Enclavamiento Mecánico
12
100-D CONTACTOR MECHANICAL INTERLOCK KIT
INSTALLATION INSTRUCTION SHEET
1 1004258
2 1016996
41053-186
OF
N/A
N/A
N/A
REVISION
AUTHORIZATION
DR.
CHKD.
APPD.
DATE
DATE
DATE
E - DOC
LOCATION: MILWAUKEE, WISCONSIN U.S.A.
B-vertical.ai
DWG.
SIZE
SHEET
B
1234 56 78
A
B
C
D
E
F
G
H
REFERENCE
DIMENSIONS APPLY BEFORE
SURFACE TREATMENT
(DIMENSIONS IN INCHES)
TOLERANCES UNLESS
OTHERWISE SPECIFIED
.XX:
.XXX:
ANGLES:
41053
G. Ushakow 1-3-06
1-3-06
1-3-06
M. Jutz
T. Hart
1
21
2
43
2
1
1.4 N·m
(12 lb-in)
100-D95...D420 Only
Nur
Seulement
Soltanto
Solo
2.7 - 4.1 Nm
(24 - 36 lb-in)
100-D210…420
100-D95…180
4.5 - 5.6 Nm
(40 - 50 lb-in)
100-D630…860
15.9 - 18.1 Nm
(140 - 160 lb-in)
2.7 - 4.1 Nm
(24 - 36 lb-in)
100-D210…420
100-D95…180
4.5 - 5.6 Nm
(40 - 50 lb-in)
100-D630…860
15.9 - 18.1 Nm
(140 - 160 lb-in)
THIS DRAWING IS THE PROPERTY OF
ROCKWELL AUTOMATION, INC.
OR ITS SUBSIDIARIES AND MAY NOT BE COPIED,
USED OR DISCLOSED FOR ANY PURPOSE
EXCEPT AS AUTHORIZED IN WRITING BY
ROCKWELL AUTOMATION, INC.