Owner manual

Troubleshooting 5-7
Type 0 Time Flt The converter has not received a type 0 status
message within the specified time.
Use I/O Sent The converter has begun sending drive-specific
control information.
Figure 5.3 – Example Parameter 03 Display im HyperTerminal
Table 5.8 – For MDI Drives
Code Event Description
F0 No Event No event present in the event queue.
F1 Adapter Reset The converter was reset by the user.
F2 Slave Detected A slave was detected to be present by the
master.
F3 Slave Removed A slave was detected to be removed by the
master.
F4 Host Timeout A timeout condition on Msg to Host.
F5 Slave Timeout A timeout condition on Msg to Slave.
F6 Master Timeout A timeout condition on Msg to Master.
F7 Serial Timeout A timeout on Serial 232 side (with control
enabled).
F8 Control Enabled The converter has sent a “Soft Control
Enable” command to the drive.
F9 Control Disabled The converter has sent a “Soft Control
Disable” command to the drive.
F10 EEPROM Sum Flt Startup sequence detected corrupt
EEPROM storage in the converter.
Table 5.7 – For DPI Drives
Events Description
Press the UP ARROW or DOWN ARROW key to scroll through the
parameter list. Press the LEFT ARROW or RIGHT ARROW key to
m
odify parameter values. Press the ENTER key to save a new
value.
1> Clr Event Queue = Enable