User Manual

6–38 Parameters
Publication 1336 FORCE–5.18 ––March, 1999
460
Trend 1 Continuous Trigger
[Tr1 Cont Trigger]
Tr1 Cont Trigger specifies the type of trend. You can
choose either 0 for one–shot or 1 for continuous.
With a one–shot trend, once the trigger condition is
true and the number of samples after the trigger is
taken are gathered, the trend stops.
With a continuous trend, once the trigger condition is
true and the number of samples after the trigger is
taken are gathered, the trend continues looking for
the next occurrence of a true trigger condition.
Parameter Number 460
Parameter Type Read/Write, Non–Linkable Sink
Display Units / Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 1
File – Group Diagnostics – Trend Setup
461
Trend 1 Select
[T r1 Select]
Tr1 Select specifies the trend mode. The states are
as follows:
0 Disable the trend.
1 Enable the trend.
2 Force a true trigger condition.
Parameter Number 461
Parameter Type Read/Write, Non–Linkable Sink
Display Units / Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 2
File – Group Diagnostics – Trend Setup
Enums 0 = Disable 1 = Enable 2 = Force Trig
462
Trend 1 Status
[T r1 Status]
Tr1 Status identifies which state the trend is
currently in. The following states are possible:
1 Stopped Trending is not executing.
2 Running Trending is executing, but the trigger
point has not yet been reached.
3 Tripped/Trigger Trending is executing, and the trigger
point has been reached.
4 Tripped/Forced The trigger point was forced.
Parameter Number 462
Parameter Type Read Only, Non–Linkable Source
Display Units / Drive Units None
Factory Default 1
Minimum Value 1
Maximum Value 4
File – Group Diagnostics – Trend I/O
Enums 1 = Stopped 2 = Running
3 = Trip Trig 4 = Force Trip
463
Trend Output 1
[Trend Out 1]
Trend Out 1 displays the latest 500 trend input data
values once the trigger condition is true and all post
samples are gathered. This parameter is updated at
the same rate as the data was sampled. This
parameter can be linked to Analog Output (for
example) and a chart recorder connected to Analog
Output to provide a hard copy of the trend data.
Parameter Number 463
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
File – Group Diagnostics – Trend I/O