User Manual

8–3Using the Trend Features

Publication 1336 FORCE–5.18 ––March, 1999

5. Select the number that corresponds to the desired operator using

the table below:

Number

This

Operator

Compare:

0 GT (Greater Than) Data Values for X and Y

1 LT (Less Than) Data Values for X and Y

2 EQ (Equal) Data Values for X and Y

3 NE (Not Equal) Data Values for X and Y

4 AND 16–bit word in X to a 16 bit mask in Y

5 NAND (Negated AND) 16–bit word in X to a 16 bit mask in Y

6 OR 16–bit word in X to a 16 bit mask in Y

7 NOR (Negated OR) 16–bit word in X to a 16 bit mask in Y

Important: Remember that the trigger condition is compared in the

following manner [Variable X] [Operator] [Variable Y].

If you are programming

Trend:

Then enter the operator in:

1 Parameter 457

2 Parameter 467

3 Parameter 476

4 Parameter 486