Manual

Serial Port Parameters
Firmware Version 1.01-3.01
Chapter 4
4-11
Parameter 62  Frequency Source Read Only
Units Code
Min V alue 0
Max Value 13
This parameter reports to the drive which frequency source is currently
being used to command the drive.
0 — Local speed pot
1 — 0 to +10V input
2 — 4 – 20mA input
3 — Pulse train input
4 — Serial input
5 — Remote speed pot input
6 — Jog selected
7 — Preset Speed 1
8 — Preset Speed 2
9 — Preset Speed 3
10 — Preset Speed 4
11 — Preset Speed 5
12 — Preset Speed 6
13 — Preset Speed 7
Parameter 63  Pulse Input Read and Write
Units Hertz
Min V alue 0.00
Max Value 250.00
This parameter represents the output frequency to be produced by the pulse
input at TB2, Terminal 8.
Parameter 64  Serial Frequency Read and Write
Units Hertz
Min V alue 0.00
Max Value 250.00
Factory Setting 0.00
This parameter sets the output frequency that will be used as the Command
Frequency when serial communication is used for speed commands.