Manual

Serial Port Parameters
Firmware Version 1.01-3.01
Chapter 4
4-12
Parameter 65  Command Frequency Read Only
Units Hertz
Min V alue 0.00
Max Value 250.00
This parameter represents the present drive command frequency set by the
current command source. The current command source will be indicated by
a code from 0-9 and shown by selecting Parameters 5 or 6.
Parameter 66  Output Frequency Read Only
Units Hertz
Min V alue 0.00
Max Value 250.00
This parameter represents and will display the actual output frequency of
the drive and will change as programmed parameters interact with the
Command Frequency, Parameter 65. It is used in the PLC Controller
Discrete Transfer.
Parameter 67 Output Pulses Read Only
Units 1 Rev/256
Min V alue 0
Max Value 65535/256
This parameter represents the angular position of the output waveform to 1
in 256 parts of an output cycle. It will continually increment from 0 to
65535 or 65535 to 0, then repeat as long as the drive is running.
Parameter 68  Serial Password Read and Write
Units Code
Min V alue 0
Max Value 9999
Factory Setting 0
This parameter stores the access code used with the remote handheld
programming device and is not intended to be used with remote I/O board
programming. Once set, you can read the password only through RIO
board programming.
Parameter 69  Reverse Status Read and Write
Units Code
Min V alue 0
Max Value 1
Factory Setting 0