Manual

11
Chapter
11-1
Local and Serial Port Parameter Settings
Firmware Version 2.01 and 3.01
Table 1 1 -- Parameter List for Parameters 70 to 89
Parameters 70 to 89 are local and serial port parameters that may only be
accessed with Firmware V ersion 2.01 and 3.01.
Local
Programming Serial
Panel Port
Parameter Parameter Min/Max Min/Max Factory
Number Text Units Values Values Setting
70 BASE DRIVER BOARD VERSION Code --- --- ---
71
CONTROL BOARD VERSION Code --- --- ---
72 ACTIVATE P
ARAMETERS 7376 Off/On 0/1 0/1 0
73
PRESET FREQUENCY 4 Hertz .0/250 0.00/250.00 .0
74
PRESET FREQUENCY 5 Hertz .0/250 0.00/250.00 .0
75 PRESET FREQUENCY 6 Hertz .0/250 0.00/250.00 .0
76
PRESET FREQUENCY 7 Hertz .0/250 0.00/250.00 .0
77
ABOVE FREQUENCY CONT ACT Hertz 0/250 0/250 0
78 TRA
VERSE PERIOD Seconds 0/30 0.00/30.00 0
79
MAXIMUM TRA VERSE Hertz .0/100 0.00/100.00 .0
80 INER TIA COMPENSA TION Hertz .0/20.0 0.00/20.00 .0
81 SOFT START/ST
OP ENABLE Off/On --- --- ---
82 AMP LIMIT FAULT ENABLE Off/On 0/1 0/1 0
83
RUN BOOST Volts 0/115 0/115 0
84
ANALOG INVERSE Off/On 0/1 0/1 0
85 RESTART TRIES Code 0/9 0/9 0
86 FAULT BUFFER 0 Code 0/37 0/37
87 FAULT BUFFER 1 Code 0/37 0/37 ---
88 FAULT BUFFER 2 Code 0/37 0/37 ---
89 FAULT BUFFER 3 Code 0/37 0/37 ---