User Manual, Firmware rev. 3.0 or LATER Owner's manual

216 Publication 1404-UM001F-EN-P - November 2009
Appendix A Powermonitor 3000 Data Tables
13 40714 Accumulated time
Integer
0…9999 Seconds -
14 40415 Accumulated time
Exponent
-1…21 - -
15 40716 Clear time
accumulator
command
0…1 - 0
(1)
On the M6 and M8, setpoint #19 and #20 default to detect voltage sag and voltage swell. See Sag and Swell, page 174.
Setpoint Setup/Read-back Select and Status
Element
No.
Modbus
Address
Element name Range Units Default
Value
Comment
List of Setpoint Types Parameters
Applies to Setpoint Setup/Read-back Select and Status Parameters on page 215
.
PM3000 Type See table
List of Setpoint Types
Param.
No.
Parameter Name M4
M5
M
6
M
8
Comment
0 Not used •••Disables the setpoint
1
Voltage
(1)
•••Refer to Metering Voltage, Current, and Frequency Result Parameters
2
Current
(1)
•••
3 Voltage unbalance •••Refer to
Metering Sequence Voltage, and Current Results Parameters
4 Current unbalance •••
5 Neutral current •••
6W •••Refer to
Metering Power Results Parameters
7VAR •••
8VA •••
9 Total true PF •••Refer to
Metering Power Factor Results Parameters
10 Total disp PF •••
11 Total dist PF •••
12 W demand •••Refer to
Metering Demand Results Parameters
13 VAR demand •••
14 VA demand •••
15 Amp demand •••
16 Projected amp demand •••
17 Projected W Demand •••
18 Projected VAR Demand •••
19 Projected VA Demand •••
20 Frequency •••Refer to
Metering Voltage, Current, and Frequency Result Parameters
21 Phase rotation •••Refer to Metering Sequence Voltage, and Current Results Parameters