User Manual, Firmware rev. 3.0 or LATER Owner's manual

218 Publication 1404-UM001F-EN-P - November 2009
Appendix A Powermonitor 3000 Data Tables
Setpoint Output Actions Parameters
Applies to Refer to
Setpoint Setup/Read-back Select and Status Parameters on page 215
PM3000 Type See table
Setpoint Output Actions
Param.
#
Parameter Name M4
M5
M
6
M
8
Comment
0 None •••No output action, but recorded in the event log and Setpoint status
recorded
1 Energize relay and set alarm flag 1 •••Refer to
Discrete Data Parameters
2 Energize KYZ and set alarm flag 2 •••
3 Set alarm flag 3 •••
4 Set alarm flag 4 •••
5 Set alarm flag 5 •••
6 Set alarm flag 6 •••
7 Set alarm flag 7 •••
8 Set alarm flag 8 •••
9 Set alarm flag 9 •••
10 Set alarm flag 10 •••
11 Set alarm flag 11 •••
12 Set alarm flag 12 •••
13 Set alarm flag 13 •••
14 Set alarm flag 14 •••
15 Set alarm flag 15 •••
16 Set alarm flag 16 •••
17 Save a trend log record •••Saves record even if periodic trending is disabled
18 Clear kWh result •••
19 Clear kVARh result •••
20 Clear kVAh result •••
21 Clear Ah result •••
22 Clear all energy results •••