Manual

104 Rockwell Automation Publication 1407-UM001G-EN-P - April 2013
Chapter 4 CGCM Unit Configuration
Fault Relay Tab
The Fault Relay tab is used to configure the unit’s parameters related to the fault
relay output. Checking the box enables the fault output for that particular fault.
The fault output relay operates when a selected fault occurs if the fault output is
enabled, and the corresponding fault tag in the Output (Scheduled Write) Data
table is set. In Series B devices with firmware revision 3.4 or earlier, the fault relay
operates if either the enable box is checked or the corresponding fault tag in the
Output (Scheduled Write) Data table is set.
Related Parameters
• Fault output enable tags in the Output table