Instruction Manual

Rockwell Automation Publication 1408-UM001D-EN-P - September 2013 11
PowerMonitor 1000 Overview Chapter 1
Hardware Features
PowerMonitor 1000
EtherNet/IP
ACT LNK
STATISRS-485
RS-485
+ - SHLD
RX TX Mod Net
1
2
34
5
6
7
8
10
11
12
13
9
Feature Description
1. Ethernet network port -
standard RJ-45 jack with
status indicators
Ethernet network port hardware is included on all models. The port functions only on units ordered with or upgraded to
the Ethernet network. The following protocols and functions are supported.
• EtherNet/IP
• Modbus TCP
• HTML Web page for configuration and data access
• LNK indicator
– Solid GREEN: IP link established
– Off: no link established
• ACT indicator
– Flashing YELLOW: data present on Ethernet port
– Off: no data activity present
2. Serial port - three-pin RS-
485 connector
All models include RS-485 serial communication that support the following protocols and functions.
• DF1 half-duplex slave
• DF1 full-duplex
• Modbus RTU slave
• Configuration using the HyperTerminal communication tool
• DH-485
3. Serial port status indicators • TX indicator flashes YELLOW when data is being transmitted
• RX indicator flashes YELLOW when data is being received
4. LCD • Unit configuration
• Data display
5. Module and network status
indicators
• Module indicator
– GREEN: Normal operation
– Alternating RED/GREEN: Performing self-test
– RED (solid or blinking): Initial power-up or failed self-test
• Network indicator
– GREEN: Ethernet connection established
– Blinking GREEN: Ethernet port looking for a connection
– RED: Duplicate IP address detected
6. LCD interface buttons • Unit configuration
• Data display navigation